日本安立计器ANRITSUStationary Surface Temperature probes
固定表面测温测温探头
Number of contacts enablingmeasurement within the accuracy range on a flat and smooth metalsurface at a temperature of 300°C(or at the operating temperaturelimit if the operating temperature limit is below 300°C).
在300 °C的平滑表金属表面上，在所示精度范围内可接触测试的次数
（ 如是要在300°C度以下，以使用极限温度为准）
日本安立计器ANRITSU
Moving / Rotating Surface Temperature probes
移动/旋转表面测温探头
Time period in which measurement wasachieved within the accuracy range, on a flat and smooth metalsurface moving at a rate of 200 m/min.
以200m/分速度移动的平滑金属表面上，在所示精度范围内可测试的时间。
日本安立计器ANRITSU
Liquid or Gas Temperature probes
液体或气体测温探头
When used correctly, virtually nodeterioration occurs in these products due to temperature measuringoperations.
Therefore, the durability ranking is based on the ease with whichimpact results in damage.
在使用正确的条件下，基本上不会出现因温度测试而引起劣化现象。耐用性是根据碰撞等条件下的易破损程度。
日本安立计器ANRITSU
Operating temperature limit
工作温度限制
The operating temperature limit isdetermined by the allowable temperature limit of the sensor headcontacts the measurement target.
Note that the operating temperature limit is not the same as theallowable temperature limits of the grip, cord, and plug.
Note that probes are more easily damaged at temperatures below 0°C,due to frost adhesion, reduced elasticity constant, and otherfactors.
使用根限温度是根据接触测试对象的感应器顶端的的耐热温度来决定。请注意，夹扣、电线和插头部分的耐热温度与使用极限温度
有一定差异。
（此外还请注意，在 0°C以下使用时因蒙霜或弹性降低等因素容易造成破损）
日本安立计器ANRITSU
About products made of polyimide
聚酰亚氨探针
Some Anritsu Meter products are madeof polyimide.
Since polyimide may adversely affect humans, avoid using suchproducts in applications where they may come into contact withfood, internal organs, or bodily fluids.
本公司提供了的一部分产品中使用了聚酰亚氨。
聚酰亚氨有可能对人体带来不良影响在与食品和体内液体直接接触的情况下请避免命使用。